How to adjust the length and size of the replica watches strap

How do you use the clock regulator? How to adjust the length and size of the strap? Since each person's brush is different in size, in order to meet the size of a large watch. The belt fake watch is usually too long from the factory. When you buy a new replica watches, the first step is to adjust the length and size of the strap. The general instruments of the meter are counters and hammers. If there is no hammer, use the rear knob of the counter knob.

The most commonly used instruments for measuring tuners are instrument controllers and hammers. If there is no hammer, use the rear knob of the counter knob. Using the counter - the regulator is easy to understand. Tie the strap in the same way and place it on the counter's pick-up knob and turn the knob directly. Please note that the strap must ensure that the strap is not threaded, but it is filled with nails or studs. It may be from the small mouth to the top of the mouth.

1. Compare the direction of the circuit. Please carefully browse the front of the belt behind the arrow on your hand, the lower overall chain of the lower arrow of the hand according to the various aspects of the arrow tsvyala directional arrow, replica Rolex put the form into the groove adjustment table. Figure 1)

2. Remove the clock nail. Remove the handle puller counter, place the replica watches in the slot and hold the watch steel needle gauge to measure the fluid, pointing it in the hole to its iholnu hour range, for example (Figure 2). If the range is long, it is recommended to unbalance the same number of parts on both sides of the hour chain when wearing the fake watch.

3. Reinstall the clock screw. Before removing the strap to the proper size, connect the two broken fake rolex straps and then press the steel needle or press the hammer in the second step. (Note: In the opposite direction of reshaping the better strap insert arrow, and select the needle to relieve the first end of his load.